A homemade furnace for a bath without much difficulty can be made yourself without spending any means on hiring workers all the more it will be much more pleasant to realize that you put the stove yourself without outside help.
In order to fold the stove you will need:
400 pieces of ordinary red bricks with dimensions 25x12x6.5
44 pieces of fire -resistant brick
Door covering the heating compartment with dimensions 22×25 cm
A door that will cover a blow with dimensions 13*14 cm
A grate with dimensions 30×25 cm
Potter with dimensions 30×20 cm
Ordinary clay
River sand
Subtoper sheet with dimensions 60×70 cm
The masonry of the foundation
Masonry of homemade furnaces for a bath with your own hands in any case begins that you need to fill the foundation. For the foundation, it is necessary to dig a recess to the level where the earth begins to freeze. The size of the foundation should be larger than the furnace itself by about 10-12 cm. A dense row of bricks is laid out to the bottom of the dug recess, which then needs to be poured with a fastening solution. The remaining rows of bricks are laid out on top of the solution. If instead of brick you spread stones, then the gaps between them should be filled with small stones and pour a solution. The foundation should be laid out until the height from the foundation to the ground will be one brick row. After that, the foundation should be isolated from the walls of the stove by roofing material (2-3 sheets). Well, the foundation is laid and now you can start building the main part of the furnace.
The laying order of the furnace
You should lay out your future furnace in the following order: two rows of bricks with a clay solution should be laid out on the roofing ground, as shown in the figure in. On the 3rd and 4 row, it is necessary to install a blower door and the so -called ash. 5 and 6 should be blocked by the blowing door and install the grate so that it is fashionable to get rid of the ashes. On the 7th row, the method of brief masonry must be laid out the fuel compartment and the horizontal channel for puffing smoke. The fuel compartment must be laid out using fire -resistant bricks, it is laid out as shown in the figure in paragraphs B and G. Having reached the 9th row, the horizontal channel should be divided into 2 chimney. At the height of the thirteenth and fourteenth rows, the fuel compartment should be laid with fire -resistant bricks and then up to the sixteenth row of chimneys laid out identical to each other. During masonry, using a wet towel, it is necessary to polish the channels and smear the cracks.
Having reached 16 and 18 rows, the pass should be laid out. A valve is installed on the seventeenth row. 19 and 20 rows are final. Below is a stove masonry scheme with your own hands. If you correctly followed this article, then you should get a wonderful strong stove, which will last more than one year!
Photos for a bathhouse with your own hands
DIY masonry
1 — ash; 2 — horizontal channel; 3 — gate
DIY stoves video